← Power Mechanics / 2 Related Drawing

2.1 Isometric projection

Power Mechanics · Grade 11 · 10 lessons in the design

What you will be able to do

  • describe isometric projection as used in drawing
  • draw basic shapes in isometric projection
  • construct circles and arcs in isometric projection
  • convert given orthographic views into isometric projection
  • appreciate the application of isometric projection in real life

Key questions

“Why is isometric projection important in real life?”

“How are skills on isometric projection applied in power mechanics?”

Lessons

The titles are open to everyone. Reading a lesson needs an account — sign in or create one.

  1. Three axes at 30 degrees
    40 min · 1 practice tasks · quiz
    Set out the isometric axes, one vertical and two at 30 degrees to the horizontal, and read the angles at the near corner.
  2. The isometric scale
    40 min · 1 practice tasks · quiz
    Construct isometric lengths with a 45 degree line and a 30 degree line, using the factor 0.816.
  3. A cube two ways
    40 min · 1 practice tasks · quiz
    Draw a 50 mm cube with true lengths, then the same cube as a projection with edges of 40.8 mm.
  4. A cuboid on the three axes
    40 min · 1 practice tasks · quiz
    Draw an 80 by 50 by 40 block in isometric drawing, length to the right, depth to the left, height vertical.
  5. Lines that are not on the axes
    40 min · 1 practice tasks · quiz
    Plot the ends of a sloping edge with isometric coordinates, and do not scale the slope itself.
  6. A circle on a face
    40 min · 1 practice tasks · quiz
    Plot a 40 mm circle on an isometric face with the offset points 12 mm and 16 mm, inside a rhombus that the curve does not corner.
  7. A compass approximation
    40 min · 1 practice tasks · quiz
    Build the four-centre compass oval in the rhombus, and treat it as an approximation of the plotted circle.
  8. A rounded corner
    40 min · 1 practice tasks · quiz
    Draw one quarter-circle of radius 15 mm on an isometric plate, using the points 9 mm and 12 mm from its centre.
  9. From orthographic sizes
    40 min · 1 practice tasks · quiz
    Crate an 80 by 50 by 40 block, then remove a full-depth step 30 mm long and 15 mm deep from the top.
  10. A wheel chock
    40 min · 1 practice tasks · quiz
    Draw a 100 by 60 by 40 chock that slopes to the ground, and say what the picture is for.